Paraguay Aluminium Scrap Recycling Process

Aluminium Scrap

Paraguay Aluminium Scrap Recycling Process

Paraguay Aluminium Scrap Recycling Process

These can be removed via Paraguay Aluminium Scrap Recycling Process or in the melting furnaces.
Scrap such as used beverage cans (UBCs) and turnings sometimes require the removal of coatings or oils prior to melting, to improve metal recovery and to reduce potential emissions.
The choice of furnaces is to a large extent determined by the level and type of impurities.

Aluminium Scrap

Adtech Refining Flux Application
Fine white ( gray) powder shaped, main components are chloride and villiaumite, and other chemical compound. Been heat and screen treatment,this product has even granularity,which is convenient for boiling kiln.Widely applied for the refining of casting Aluminum / Alloy in reverberatory furnace and holding furnace.

Paraguay Aluminium Scrap Recycling Process-Refining Flux Performance
The product powder carried by carrier gas ( N , Ar) evenly goes under 2 molten Aluminum through powder spraying boiling kiln, after physicochemical response and forms tiny bubbles that fully access with molten aluminum,and get rid of Hand other harmful gas,moreover, there are some material in the product that can strongly attach or absorb oxides and other impurities and who carry them to surface,so that purification can be done.

Adtech Refining Flux Advantages
1.Good Liquidity, good performance in deslagging and degassing.
2.Good purification, less pollution, less dosage, low cost.
3.Easy separation of aluminum and slag.

Combinations of different scraps (sized and/or pre-treated) are selected based on the analysis of their alloy composition for charging into the melting furnaces.

refining flux

AdTech ceramic foam filter for Paraguay Aluminium Scrap Recycling Process
Specifications: 7*7in 9*9in 12*2in 15*15in 17*17in 20*20in 23*23in 26*26in, or customized according to customer requirement.
Pore size (mesh): 25 30 35 40 45 50 55 60.
Performance and application:
Filter-PZr filter is produced from high temperature sintering ZrO2 molten material, usable at high temperature, high strength, erosion resistance, minimal volume change, can effectively filter out micron-scale inclusions in molten aluminum, mainly used in aviation, transportation and other aluminum alloy precision casting.
Aperture microgram: (Aperture microgram)

Ceramic Foam Filter Features
-Reduce scrap related to inclusions.
-Reduce costs related to inclusion defects.
-Increase productivity with higher extrusion or rolling speeds.
-Increase casting flexibility with easy alloy changes.
-No holding metal.

 

No Comments

Post A Comment